8 Channel Inductive Load Driver Arduino Shield

The  8 Channel Driver Arduino UNO Shield  is designed to enable users to switch inductive loads for up to  800mA  each channel and up to  24V DC  with no heat-sink needed. It is ideal for such applications as driving  2x unipolar stepper motors,  solenoids, relays,  and  small DC motors. It uses 2x  DRV8803  Chip from  Texas instruments  which is 4 channel low side driver with over current protection. IC’s Internal shutdown protection function is provided for overcurrent protection, short circuit protection, under-voltage lockout, and over temperature. Faults are indicated by a fault output pin that is normally high and goes low if a fault condition occurs. Reset and enable pins has internal pull-down resistors.